This new Oak Veneered board works extremely well for laser engraving and cutting, as it is a veneer, care needs to be taken to not engrave too close to the edge or you can get some small amounts of breakout.
Used in the modernised cockpit of a WW1 Sopwith Strutter Bi Plane, diode lasers work great with this
We get fantastic results using Enduramak and Hobarts sent it out in good speed for us to complete a big order.
Excellent service. Quality was very high, and my strict requirement on thickness was met perfectly.
Replaced my laser top panel as I'd leaned on it and cracked it so finally got around to replace it and go a little thicker than what they put in